Mechanically in excellent condition, and nearly rust free, the RH quarter panels needed some work.
Fixing the Rear Quarter
A section of the inner guard had to cut out and replaced.
Fabricating and installing the new inner guard section.
Fabricating the outer panel and lower sill sections
Mask and paint.
Fixing the Front Quarter
As expected, there was additional rust on the end of the sill box section. It had not yet perforated, but was very thin. Cleaning with a wire brush produced the holes.
The sill box section resealed. Fabricating the guard panel.
The new guard panel welded in, and after fill and primer.
Copyright 2004-2014 Lancer Project. All Rights Reserved.